Новый Dragon Link Advanced

[Redsonic]

Добавили телеметрию, bluetooth

[Fireniko]

Вообще то выглядит по другому. Ссылка на сайт производителя-продавца [Ссылки доступны только зарегистрированным пользователям Зарегистрироваться...]

Взял недавно такой комплект, буду ставить на Mini Talon

[Expert]

а на 2g не хотите поменять?

[Fireniko]

если бы хотел 2G , то не покупал бы Драгон.

На RCGroup в [Ссылки доступны только зарегистрированным пользователям Зарегистрироваться...] организована обратная связь, Майк отвечает практически онлайн на вопросы по системе.

[Fireniko]

SPECIFICATIONS
Transmitter Module Voltage: 5 - 18 Volts (2-4 cell LiPo)
Receiver Voltage: 5 - 9 Volts (UBEC or 2 cell LiPo)
Frequency: 433 MHZ - Frequency Hopping in ARS Band.
Typical Range: 40 KM Using Supplied Antennas

Заявленные возможности:

Full Bidirectional Telemetry to 50 KM with stock antennas.
Built in serial Radio Modem
Works with Mission Planner / Droid Planner ( Wish GPS installed )
Built in Bluetooth for any android Smartphone or Tablet
Fully configurable using PC software.
Configuration via android device ( in development )
Adds up to 3 Channels to your RC system with switches and knobs on top of unit
Lost plane finder - Simply see where it is on Smartphone
Configurable, Multifunction Switches and Knobs
Two Multicolor Status LED's for alarms, status, voltage, etc.
Audible alarms ( For Low Voltage in Copters, Low RSSI, Etc )
Works with current Micro Receivers.
Full Logging of flight, position, etc.
Removable SD card.
Spectrum Analyzer
Super Fast update rate for Racers and obstacle flyers.
Hassle free, no extra steps operation for those that want basic experience.
Fully compatible with Existing Dragon Link Micro Receivers ( Full Bidirectional )
Future Compatibility ( One Way ) for V2 Receivers that have Next Generation Firmware on them.
It is Dragon Link, it will outperform anything in existence.

GUI приемника.

GUI передатчика.

[Fireniko]

из документации:
The new Advanced TX will be fully compatible with the new series of receivers, consist-
ing of the MicroRx, CopterRx and Advanced 12-channel receiver. All receivers supports
bi-directional capabilities, but only the 12-channel Advanced receiver, will have full bi-
directional range. All receivers will have equal RC-range.

из форума, относительно Bidirectional и дальности

The full data is a very large bandwidth, which reduces range and performance. We are working on making the full data work at much further ranges than ever possible, but this part is going to take some time...

For now, you can get GPS, full Map, and IMU flight information. But a lot of the other stuff will not work yet. It will happen, but we are going to take our time and make it perform better than anything on the planet...

The MicroRx supports full bi-directional communication, we just wasn't able to fully use it with the V2 TX.
While the output-power is fairly limited, the beta-testing have shown solid bi-dir communication to 20 kilometers and still valid packages over 30 kilometers. Range will naturally be less in a noise-heavy area, bad installation and what not, but the bi-dir range of the MicroRx should be fine for most FPV'ers.

[Fireniko]

Full bandwidth and data support of Mission Planner and Droid Planner, with all features active will definitely happen one day. This is very important on our to do list. That being said, we are working on a lot of neat new stuff you guys will love. So that is one of a lot of important things. I could not possible give a date on this, I just have no idea when.

The full mission planner bidirectional waste a huge amount of bandwidth, which reduces performance a lot. 99 % of that is wasted. So we took the important stuff and use that for performance far beyond what anything else offers. We will support the entire bidirectional in a future firmware update, but the most important was to use useful information only at best performance first....

[Fireniko]

ALL micro receivers ever made will work with V3 with a simple firmware update. Older, larger V2 receivers will not.

[Fireniko]

из документации
The number of transmitted channels, describes how much data that's transmitted
in each data-package. The less channels transmitted, the faster update-rate.
Without bi-dir enabled and with default settings, 12 channels transmitted gives an
update-rate close to 25 Hz. Going from 12 channels to 8 channels transmitted,
will give approximately 20 % increase in update-rate. Going from 12 channels to 4
channels, yields approximately 40 % increase in update-rate. For 95 % of the users
this wont make a dierence, but if bi-dir is enabled and you are doing acrobatic,
this might be of interest. Note that this setting wont aect the servo update rate
(always a constant 50 Hz PWM).

из форума о latency

12 ch PPM is approx 30 ms
S-bus is approx 9 ms IIRC.
CRSF is approx 5 ms

RF-wise, with default settings (12 channels):
Normal with bi-dir: 40 ms
Normal without bi-dir: 20 ms
Faster update-rate with bi-dir: 20 ms
Faster update-rate without bi-dir: 10 ms
Fastest update-rate with bi-dir: 10 ms
Fastest update-rate without bi-dir: 5 ms

[Expert]

надо все мерить, написать могут все что угодно
я вот сегодня [Ссылки доступны только зарегистрированным пользователям Зарегистрироваться...] power bank 50.000 ma весом 290гр (а это минуточку 50 ампер)

может фотки хорошие сможете сделать потрошков передатчика?

и вы лучше расскажите чем вас 2g не устроил?

зы
я надеюсь вы в курсе что "but only the 12-channel Advanced receiver, will have full bi-
directional range" и 12 каналки еще даже на выпустили